Table of Contents
Advertisement
C33 Classic Freestanding Gas Stove
Classic C33 model shown above features
optional gold plated door and gold legs.
WARNING:
If the information in these instructions are not followed exactly,
a fire or explosion may result causing property damage,
personal injury or loss of life.
FOR YOUR SAFETY
Do not store or use gasoline or other flammable vapors and
liquids in the vicinity of this or any other appliance.
Installation and service must be performed by a qualified
installer, service agency or the gas supplier.
Tested by:
908-636a
FPI FIREPLACE PRODUCTS INTERNATIONAL LTD. 6988 Venture St., Delta, BC Canada, V4G 1H4
www.regency-fire.com
MODELS: C33-NG2 Natural Gas
Installer: Please complete the details on the back cover
and leave this manual with the homeowner.
Homeowner: Please keep these instructions for future reference.
Installation Manual
C33-LP2 Propane
FOR YOUR SAFETY
What to do if you smell gas:
Do not try to light any appliance
Do not touch any electrical switch:
do not use any phone in your
building.
Immediately call your gas supplier
from a neighbour's phone. Follow
the gas supplier's instructions.
If you
cannot reach your gas
supplier, call the fire department.
Owners &
01/31/05
Advertisement
Table of Contents
Related Manuals for Regency C33-LP2
Summary of Contents for Regency C33-LP2
- Page 1 Installation Manual Classic C33 model shown above features optional gold plated door and gold legs. MODELS: C33-NG2 Natural Gas C33-LP2 Propane WARNING: FOR YOUR SAFETY If the information in these instructions are not followed exactly, What to do if you smell gas:...
- Page 2 Ltd. The Regency Gas Series of hand crafted appliances has been designed to provide you with all the warmth and charm of a woodstove, at the flick of a switch. The models C33-NG2 and C33-LP2 have been approved by Warnock Hersey for both safety and efficiency. As it also bears our own mark, it promises to provide you with economy, comfort and security for many trouble free years to follow.
-
Page 3: Table Of Contents
Optional Remote Wall Switch ........12 Optional Remote Control Installation ......12 Warranty ..............23 Optional Wall Thermostat .......... 12 Wiring Diagram ............13 Final Check ............... 12 Normal Operating Sounds of Gas Appliances .... 13 Regency CLASSIC C33-2 Freestanding Gas Stove... -
Page 4: Safety Label
Gas. We have printed a copy of the contents here for your review. The safety label is located on the back panel. NOTE: Regency units are constantly being FPI Fireplace Products International Ltd. improved. Check the label on the unit and if there... - Page 5 We have printed a copy of the contents here for your review. The safety label is located on the back panel. NOTE: Regency units are constantly being im- FPI Fireplace Products International Ltd. proved. Check the label on the unit and if there...
-
Page 6: Installation
1) Clocking the appliance to ensure the cor- 11) Wear gloves and safety glasses for pro- rect firing rate (rate noted on label) after tection while doing required maintenance. burning appliance for 15 minutes. Regency CLASSIC C33-2 Freestanding Gas Stove... -
Page 7: Clearances To Combustibles
D Side Wall 22" / 559 mm 3) Remove wire from piezo ignitor. Side Wall 13" / 330 mm Minimum ceiling height is 36" / 914 mm from top of unit. Diagram 4 Diagram 2 Regency CLASSIC C33-2 Freestanding Gas Stove... -
Page 8: Pedestal Assembly
10) Take fan out from the stove body. Diagram wires). See Diagram 1. 15) Connect white wire from fan motor to neu- 4) Push the Regency logo into the two holes tral on the power cord. in the front bottom left corner of the pedestal cover plate. -
Page 9: Leg And Bottom Shield Assembly
12 ft. is used. Note: Proper sizing of gas vents is crit- ical to proper operation of all gas stoves and fireplaces. Ensure that proper sizing tables or vent man- ufacturers instructions are fol- lowed. Side View Regency CLASSIC C33-2 Freestanding Gas Stove... -
Page 10: Gas Connection
The efficiency rating of the appliance is a Natural Gas 20,400 Btu/h product thermal efficiency rating determined under continuous operating conditions and Output Capacity with blower On was determined independently of any installed Natural Gas 21,600 Btu/h system. Regency CLASSIC C33-2 Freestanding Gas Stove... -
Page 11: Test For Flue Spillage
Broken logs can interfere with the pieces from the rock wool. Gently place the installed unit is left with the customer. Follow pilot and burner operation. pieces on top of the embers. See diagram the procedure below: Regency CLASSIC C33-2 Freestanding Gas Stove... -
Page 12: Safety Latch
Regency offers an optional programmable ther- Use the Regency Remote Control Kit approved mostat but any 250-750 millivolt rated non- for this unit. Use of other systems may void anticipator type thermostat that is CSA, ULC or your warranty. -
Page 13: Wiring Diagram
Blower: be aware that as there are temperature chang- valve. Regency gas appliances use high tech blow- es within the unit these sounds will likely re- ers to push heated air farther into the room. It occur. Again, this is normal for steel fireboxes. -
Page 14: Operating Instructions
If the Note: When the glass is cold and the heat resistant paint. Regency uses Stove pilot does not remain lit, repeat operation appliance is lit, it may cause con- Brite Paint - Metallic Black #6309. -
Page 15: Copy Of Lighting Plate Instructions
2) Turn off all electric power to the appliance if clockwise to “OFF”. Do not force. service is to be performed. You may shut off the pilot during prolonged non use periods to conserve fuel. DO NOT REMOVE THIS INSTRUCTION PLATE 908-649a Regency CLASSIC C33-2 Freestanding Gas Stove... -
Page 16: General Vent Maintenance
Open - Short Blue flame Caution: Carbon will be produced if air shutter is closed too much. Note: Aeration Adjustment should only be performed by an authorized Regency Installer at the time of installation or service. Regency CLASSIC C33-2 Freestanding Gas Stove... -
Page 17: Log Replacement
If for any reason a log should need replace- your glass does break, do not ment glass from an authorized Regency dealer ment, use only Regency replacement logs. The continue to use your unit until it... -
Page 18: Removing Valve Assembly
14) Remove pilot nut with an 11 mm wrench. 6 ) Disconnect the two (2) switch wires from valve. 15) Remove valve to orifice nut with a 13/16" wrench. 7) Remove two (2) orifice bracket screws inside firebox. Regency CLASSIC C33-2 Freestanding Gas Stove... -
Page 19: Parts List
490-917 Fan Assembly (120 V) Optional 910-157/P Fan motor (120 V) 910-794 Power Cord 910-140 Fan HI/OFF/LOW switch 910-142 Fan Auto ON/OFF Thermodisc 460-006 Rear Panel 908-636 Manual *Not available as a replacement part. Regency CLASSIC C33-2 Freestanding Gas Stove... - Page 20 Rear Log Deflector Top - Propane 460-011 Deflector - Rear Burner Back (NG) 902-180 Front Log 902-186 Rear Log 902-182 Top Log (each) 904-537 3/8 x 12" black mall nipple. *Not available as a replacement part. Regency CLASSIC C33-2 Freestanding Gas Stove...
-
Page 21: Base Options
Pedestal Cover Plate 125) * Rear Cover Plate 140) 850-126 Cast Legs - Black 850-127 Cast Legs - Gold *Not available as a replacement part. 850-128 Cast Legs - Brush Nickel 142) 850-125 Steel Legs Regency CLASSIC C33-2 Freestanding Gas Stove... - Page 22 _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ ____________________________________________________________ __________________________________________________________ ____________________________________________________________ _______________________________________________________ _____________________________________________________ __________________________________________________________ _________________________________________________________ _________________________________________________________ ______________________________________________________ ______________________________________________________ _______________________________________________________________ ___________________________________________________________ __________________________________________________________ ____________________________________________________________ ____________________________________________________________ ____________________________________________________________ _____________________________________________________________ __________________________________________________________ __________________________________________________________ _____________________________________________________ ________________________________________________________ _________________________________________________________ _________________________________________________________ Regency CLASSIC C33-2 Freestanding Gas Stove...
-
Page 23: Warranty
It is the general practice of FPI to charge for larger, higher priced replacement parts and issue credit once the replaced component has been returned to FPI and evaluated for manufacturer defect. The authorized selling dealer is responsible for all in-field service work carried out on your Regency product. FPI will not be liable for results or costs of workmanship from unauthorized service persons or dealers. - Page 24 Dealer Name & Address: ______________________________________________ __________________________________________________________________ Installer: ___________________________________________________________ Phone #: ___________________________________________________________ Date Installed: ______________________________________________________ Serial No.: _________________________________________________________ Regency and Classic are trademarks of FPI Fireplace Products International Ltd. Printed in Canada © Copyright 2005, FPI Fireplace Products International Ltd. All rights reserved.
Need help?
Do you have a question about the C33-LP2 and is the answer not in the manual?
Questions and answers
Tengo una estufa REGENCY Model C33-NG2 Natural gas quiero cambiarlo a gas propano podrían hayudarme **** las partes porfavor
To convert a Regency C33-NG2 natural gas stove to propane (C33-LP2), follow these steps:
1. Shut Off Gas Supply: Close the manual shut-off valve to isolate the stove from the gas supply.
2. Change Burner Orifice: Replace the natural gas burner orifice (#36) with a propane burner orifice (#52).
3. Adjust Gas Pressure: Ensure the manifold pressure is set correctly for propane.
4. Check Venting System: Verify that the proper venting setup is used for propane operation.
5. Test for Leaks: After conversion, check for gas leaks and ensure proper pressure settings.
6. Reassemble and Test: Reconnect all components and test the appliance for safe operation.
Required Parts:
- Propane burner orifice (#52)
- Proper gas regulator for propane (if different)
- Tools such as wrenches for removing and installing components
Follow manufacturer guidelines and local codes when performing the conversion.
This answer is automatically generated