Page 1
- Installation and service must be performed by a qualified installer, service agency or the gas supplier. Tested by: Installer: Please complete the details on the back cover and leave this manual with the homeowner. Homeowner: Please keep these instructions for future reference. 919-490 REGENCY FIREPLACE PRODUCTS. 6988 Venture St., Delta, BC Canada, V4G 1H4 03.18.15...
Page 2
The models C34-NG10 and C34-LP10 of this series have been approved by Intertek for both safety and efficiency. As it also bears our own mark, it promises to provide you with economy, comfort and security for many trouble free years to follow.
Page 3
#8 appliance comes factory equipped with a means ground lug to which an 8 gauge copper wire from to secure the unit. the steel chassis ground must be attached. C34 Video Regency CLASSIC C34-10 Direct Vent Freestanding Gas Stove ®...
Page 4
Regency CLASSIC C34-10 Direct Vent Freestanding Gas Stove ®...
Converting Class-A Metal Chimney or Glass Replacement .............38 Masonry Chimney to Direct Vent System ....27 Main Assembly ............39 System Data ..............29 Burner Assembly & Log Set ........40 Gas Connection ............29 Base Options ...............41 Warranty ..............43 Regency CLASSIC C34-10 Direct Vent Freestanding Gas Stove ®...
Page 6
The State of Massachusetts requires the installation of a carbon monoxide alarm in accordance with NFPA 720 and a CO alarm with battery back up in the same room where the gas appliance is installed. Regency CLASSIC C34-10 Direct Vent Freestanding Gas Stove ®...
Page 7
(e) A copy of all installation instructions for all Product Approved side wall horizontally vented gas fueled equipm ent, all venting instructions, all parts lists for venting instructions, and/or all venting design instructions shall remain with the appliance or equipment at the completion of the installation. Regency CLASSIC C34-10 Direct Vent Freestanding Gas Stove ®...
IF THE BARRIER BECOMES DAMAGED, SURFACE TEMPERATURES, ESPE- THE BARRIER SHALL BE REPLACED CIALLY THE FIREPLACE GLASS, AND WITH THE MANUFACTURER'S BARRIER SHOULD STAY AWAY TO AVOID BURNS FOR THIS APPLIANCE. OR CLOTHING IGNITION. Regency CLASSIC C34-10 Direct Vent Freestanding Gas Stove ®...
5. This appliance must be connected to the speci- Fuels: C34-NG10 is approved for use with natural the unit must be bolted down to the floor. fied vent and termination cap to the outside of gas.
2. Ensure proper grounding using the #8 Side wall ground lug provided. See "Optional Fan Installation" section. 3. Appliance must be anchored to the floor. See "Pedestal Assembly" & "Leg and Bottom" sections. 10 | Regency CLASSIC C34-10 Direct Vent Freestanding Gas Stove ®...
5. Place the fan assembly partially in door cover plate hole. See Diagram 4. 6. Attach the 2 ground wires (green) to the ground lug as per Diagram 4. Diagram 7 919-512 02.18.15 Regency CLASSIC C34-10 Direct Vent Freestanding Gas Stove ®...
Page 12
(Diagram 5). 7. Turn fan 90 degrees. (Diagram 5). (Pedestal units only). 8. Disconnect the green ground wires to the grounding lug. Remove fan from stove. (Diagram 3) 02.18.15 919-512 12 | Regency CLASSIC C34-10 Direct Vent Freestanding Gas Stove ®...
Anchoring Brackets Hold Down Package Part# 846-585 Note: Any paint touch up should be done prior to placing logo on pedestal. Regency CLASSIC C34-10 Direct Vent Freestanding Gas Stove ®...
"Venting Freestanding Gas Stove, C34-NG and C34-LP, the C34-NG10 and the C34-LP10. The warranty will Arrangment" section to determine if they are have been tested and listed as direct vent heater be voided and serious fire, health or other safety required for your installation.
* Clearance in accordance with local installation codes and the requirements of the gas supplier 3 feet (91cm) within a height of 15 feet (4.5m) above the meter / regulator assembly 3 feet (91cm) above - if within 10 feet (3m) horizontally Regency CLASSIC C34-10 Direct Vent Freestanding Gas Stove ®...
SV4BF TM-4CS Trim Plate-Black 4DT-TP 4DFPB 4DcP SV4LA TM-4TP Regency Fireplace Products . 6988 Venture St. . Delta, BC . Canada . V4G 1H4 . 604-946-5155 . www.regency-fi re.com 16 | Regency CLASSIC C34-10 Direct Vent Freestanding Gas Stove ®...
Page 17
Never allow the vent to run downward - this could cause high temperatures and may present a possible fi re hazard. Regency Fireplace Products . 6988 Venture St. . Delta, BC . Canada . V4G 1H4 . 604-946-5155 . www.regency-fi re.com...
, Selkirk Direct-Temp. AstroCap is a proprietary trademark of FPI Fireplace Products ® International Ltd. Dura-Vent® and Direct Vent are registered and/or proprietary trademarks of Simpson Dura-Vent Co. Inc. 18 | Regency CLASSIC C34-10 Direct Vent Freestanding Gas Stove ®...
Offset to Vertical Vent. A 15 ft. vertical run with 4 ft. horizontal offset distance falls within the shaded area and is an allowable installation with Vent Restrictor Position "R" (Right). Regency CLASSIC C34-10 Direct Vent Freestanding Gas Stove ®...
Page 20
90 elbows is 5' Min. 8' Max. 6' Min. required. Lengths do not include elbow indicated. Vent restrictor position C (fully open), refer to "Vent Restrictor Position" section 20 | Regency CLASSIC C34-10 Direct Vent Freestanding Gas Stove ®...
DV 2 ft. Stove Vent Kit (Part # 946-116) and DV 4 ft. Stove Vent Kit (946-216) include all the parts needed to install the C34 with minimum horizontal and vertical vent dimensions. For installations that require longer vertical and/or horizontal vents use the Dura-Vent system as shown in "Dura-Vent Termination Kit"...
Page 22
Note: pilot holes will need cone. to be drilled through the wall thimble on all 12. Install the spring spacers onto the pipe 4 corners. 22 | Regency CLASSIC C34-10 Direct Vent Freestanding Gas Stove ®...
Security Secure Vent , Selkirk Direct-Temp. AstroCap is a proprietary trademark of FPI Fireplace ® Products International Ltd. Dura-Vent® and Direct Vent are registered and/or proprietary trademarks of Simpson Dura-Vent Co. Inc. Regency CLASSIC C34-10 Direct Vent Freestanding Gas Stove ®...
Hint: Apply silicone to female end. the snorkel upside down. b) Horizontal runs of vent must be sup- ported every three feet. Wall straps are available for this purpose. 24 | Regency CLASSIC C34-10 Direct Vent Freestanding Gas Stove ®...
Wall will penetrate the roof. Determine if ceiling straps are available for this purpose. See diagram 9. Regency CLASSIC C34-10 Direct Vent Freestanding Gas Stove ®...
2. Place the support in the opening. Lower it to the correct height as determined by the table and diagram below. Using a level, make sure the support is vertical. 26 | Regency CLASSIC C34-10 Direct Vent Freestanding Gas Stove ®...
The direct vent system must not be connected to a damaged factory-built or masonry chimney. Diagram 1 Diagram 5 Regency CLASSIC C34-10 Direct Vent Freestanding Gas Stove ®...
Page 28
Diagram wall. 28 | Regency CLASSIC C34-10 Direct Vent Freestanding Gas Stove ®...
(clockwise) with a 1/8" flat screwdriver. Screw should be snug, but do not over tighten. Regency CLASSIC C34-10 Direct Vent Freestanding Gas Stove ®...
Page 30
DC Sparker Box by opening the battery 8. Main Gas Outlet compartment. 9. Alternative TC Connection Point NOTE: The battery in the DC Sparker Box will need to be replaced annually. Pedestal base shown 30 | Regency CLASSIC C34-10 Direct Vent Freestanding Gas Stove ®...
The flat side of the log other. (Use Extreme Caution and ensure facing the back of the unit. Carefully push proper light off of burner.) the log down onto the pins. See diagram 3. Regency CLASSIC C34-10 Direct Vent Freestanding Gas Stove ®...
3. Check for proper draft. CAUTION Any alteration to the product that causes sooting or carboning that results in damage to the exterior facia is not the responsibility of the manufacturer. 32 | Regency CLASSIC C34-10 Direct Vent Freestanding Gas Stove ®...
Top View of pilot flame Incorrect flame pattern will have small, prob- ably yellow flames, not coming into proper contact with the rear burner or thermopile or thermocouple. Top View of pilot flame 34 | Regency CLASSIC C34-10 Direct Vent Freestanding Gas Stove ®...
7. The unit should never be turned off, and on again without a minimum of a 60 second wait. Diagram 1 8. Hook up remote receiver to wire marked 'receiver' Regency CLASSIC C34-10 Direct Vent Freestanding Gas Stove ®...
Mettre le bouton de commande de gaz en position OFF pour éteindre la veilleuse. Pour économiser le carburant, éteignez la veilleuse quand l’appareil reste longtemps inutilisé. DO NOT REMOVE THIS INSTRUCTION PLATE 919-456 36 | Regency CLASSIC C34-10 Direct Vent Freestanding Gas Stove ®...
6. Keep the area near the appliance clear and the unit’s performance which is not free from combustible materials, gasoline covered under warranty. and other flammable vapours and liquids. Regency CLASSIC C34-10 Direct Vent Freestanding Gas Stove ®...
Top Relief Plate Gasket 290-021 Air Baffle Plate Capscrew 1/4 x 1-3/4" NC Upper Air Passage Assembly 490-081 Flue Restrictor 490-520 Top Assembly 490-042 Rear Panel 919-490 Manual *Not available as a replacement part. Regency CLASSIC C34-10 Direct Vent Freestanding Gas Stove ®...
Deflector-Top Rear Log - NG 490-068 Deflector-Top Rear Log - LP 490-932 Complete Log Set 902-151 Ember 902-153 Rockwool 904-537 Gas Inlet Pipe (12") Not available as a replacement part Not shown 40 | Regency CLASSIC C34-10 Direct Vent Freestanding Gas Stove ®...
490-005 Access Panel 125. 490-002 Rear Cover Plate 140. 850-126 Cast Legs - Black (4/set) *Not available as a replacement part. 850-128 Cast Legs - Brush Nickel (4/set) 493-926 Complete Pedestal Regency CLASSIC C34-10 Direct Vent Freestanding Gas Stove ®...
Page 42
42 | Regency CLASSIC C34-10 Direct Vent Freestanding Gas Stove ®...
It is the general practice of FPI to charge for larger, higher priced replacement parts and issue credit once the replaced component has been returned to FPI and evalu- ated for manufacturer defect. The authorized selling dealer is responsible for all in-fi eld service work carried out on your Regency product. FPI will not be liable for results or costs of workmanship from unauthorized service persons or dealers.