Huawei SmartAX MA5603T Configuration Manual page 223

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Prerequisites
You must be logged in to the MA5600T/MA5603T/MA5608T from the console (also called
maintenance terminal) through the serial port, and must enter the global config mode.
Tools, Meters, and Materials
RS-232 serial port cable (used for logging in to the MA5600T/MA5603T/MA5608T from the
console through the serial port)
Impact on the System
None
Precautions
NOTE
l
l
l
Procedure
Step 1 Query the baud rate of the serial port on the MA5600T/MA5603T/MA5608T.
huawei(config)#display baudrate
Current active serial baudrate: 9600 bps
Step 2 (This step is optional but is required when you reconfigure the baud rate of the serial port.) Run
the baudrate command on the MA5600T/MA5603T/MA5608T to configure the baud rate of
the serial port on the MA5600T/MA5603T/MA5608T. The high baud rate can increase the
transmission speed.
For example, reconfigure the baud rate on the MA5600T/MA5603T/MA5608T to 9600 bit/s:
huawei(config)#baudrate 9600
Step 3 Open the HyperTerminal on the console to configure the baud rate of the serial port on the
console to be the same as the baud rate on the MA5600T/MA5603T/MA5608T.
Issue 01 (2014-04-30)
l The speed of transferring files in Xmodem mode through the serial port is limited. Therefore, the system
does not support file transfer in the Xmodem mode for large-size files such as program packet files
and configuration files.
l It is recommended to transfer files through other modes as much as possible, such as TFTP, even if
file transfer in the Xmodem mode is supported.
The baud rate of the serial port on the MA5600T/MA5603T/MA5608T must be the same
as the baud rate of the serial port on the console.
The Xmodem transfer mode is applicable to only the active control board.
Users who log in to the system remotely are prohibited from transferring files in Xmodem
mode.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 Commissioning
198