Fttb/C Networking (Xdsl Access, Without Hgw); Service Requirements And Application Scenario - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
l
----End

11.3.2 FTTB/C Networking (xDSL Access, Without HGW)

In the Fiber-to-the-building/curb (FTTB/C) network, an optical network unit (ONU) supports x
digital subscriber line (xDSL) and plain old telephone service (POTS) access and provides
Internet access and voice over IP (VoIP) services. This topic describes the OLT and ONU
configurations required for commissioning Internet access and voice services.

11.3.2.1 Service Requirements and Application Scenario

Generally, Fiber-to-the-building (FTTB) applies to high-density residential areas or commercial
centers. Users can access service aggregation nodes using the local area network (LAN) and x
digital subscriber line (xDSL). Fiber-to-the-curb (FTTC) applies to low-density residential areas
such as villas. xDSL is mainly used in the FTTC scenario because the subscribers are as far as
300 m to 3000 m from the fiber distribution terminal.
Service Requirements
The FTTB/C application scenario only supports Internet access and voice services without
multicast demands.
To reuse the existing phone lines and overcome the challenges caused by long distance between
ONUs and subscribers, FTTB/C with xDSL access is recommended.
Issue 01 (2014-04-30)
huawei(config)#display pppoe simulate info
PPPoE simulate information is:
-----------------------------------------------------------------
Service-port:
User name:
Current phase: -
Result:
Start time:
End time:
Session ID:
User IP:
Gateway IP:
-----------------------------------------------------------------
3. Terminate the emulation test by running the simulate dhcp start command.
huawei(config)#pppoe simulate stop
Verify the voice service using call emulation.
1. Start an emulation test by running the ont emulational call command.
huawei(config)#test
huawei(config-test)#pots emulational-call caller-port 0/3/0 callee-port
0/3/23 callee-telno 83110024
2. The ONU outputs the call emulation result after the test is complete.
The ONU outputs the call emulation result and failure of the cause if the emulation
test fails.
huawei(config-test)#
Caller port
Callee port
Test result
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 FTTB and FTTC Solution Configuration
101
user0
Success
2011-11-16 15:41:29+08:00
2011-11-16 15:41:34+08:00
591
192.168.50.2
192.168.50.254
: 0/3/0
: 0/3/23
: Test Succeed
//*Emulation phase
//*Emulation result
881