Commissioning The Interconnection With The Mg Interface (Mgcp) - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
0
-------------------------------------------------------------------------
Configuration File
vlan 50 smart
port vlan 50 0/19 0
interface vlanif 50
ip address 10.50.1.10 24
quit
voip
ip address media 10.50.1.10 10.50.1.1
ip address signaling 10.50.1.10
quit
ip route-static 10.10.1.0 255.255.255.0 10.50.1.1
interface h248 0
y
if-h248 attribute mgip 10.50.1.10 mgport 2944 code text transfer udp domainName
MA5600T/MA5603T/MA5608T.com primary-mgc-ip1 10.14.1.4 primary-mgc-port 2944 mg-
media-ip1 10.50.1.10 start-negotiate-version 2
reset coldstart
y
quit
save

1.4.4.2 Commissioning the Interconnection with the MG Interface (MGCP)

This topic describes how to check whether the MG interface can normally communicate with
the MGC through the MGCP protocol.
Service Requirements
In the network as shown in
l
l
l
l
l
Issue 01 (2014-04-30)
UDP Normal
Figure
The MA5600T/MA5603T/MA5608T uses the MGCP protocol.
The media IP address is the same as the signaling IP address (when the MGCP protocol is
used, the media IP address must be the same as the signaling IP address), and the media
stream and the signaling stream use the same Ethernet port on the GIU board for upstream
transmission.
The media stream and the signaling stream use the default QoS policy for upstream
transmission.
Various terminals connected to the MG interface use the default TID profile, and the
software parameters of the MG interface use the default settings.
The MGC identifies the MG through the signaling IP address (IP address of the MG
interface), and their communication packets do not contain any VLAN tag.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2944 10.50.1.10
1-75, the service requirements are as follows:
1 Commissioning
2944 10.10.1.4
168