Installation/Wiring; Opening The Cover - Allen-Bradley powerflex 700 User Manual

Installation/Wiring

This chapter provides information on mounting and wiring the
PowerFlex 700 Drive.
For information on . .

Opening the Cover

Mounting Considerations
AC Supply Source Considerations 1-2
General Grounding Requirements 1-4
Fuses and Circuit Breakers
Power Wiring
Most start-up difficulties are the result of incorrect wiring. Every
precaution must be taken to assure that the wiring is done as instructed.
All items must be read and understood before the actual installation
begins.
ATTENTION: The following information is merely a guide for proper
installation. The Allen-Bradley Company cannot assume responsibility
!
for the compliance or the noncompliance to any code, national, local or
otherwise for the proper installation of this drive or associated
equipment. A hazard of personal injury and/or equipment damage
exists if codes are ignored during installation.
Opening the Cover
See page For information on. .
1-1 Disconnecting MOVs and
Common Mode Capacitors
1-2
I/O Wiring
Reference Control
1-5 Auto/Manual Examples
1-5 Lifting/Torque Proving
EMC Instructions
Frames 0-4
Locate the slot in the upper left corner.
POWER
STS
Slide the locking tab up and swing the
S.M.A.R.T. Exit Lang Auto / Man Remove cover open. Special hinges allow cover to
Esc Sel
7 8 9
move away from drive and lay on top of
4 5 6 Jog
1 2 3
adjacent drive (if present). See
.
0 +/-
Alt
Exp Param #
for frame 4 access panel removal.
PORT
Frame 5
MOD
NET A
NET B
Slide the locking tab up, loosen the
right-hand cover screw and remove. See
page 1-7
Frame 6
Loosen 2 screws at bottom of drive cover.
CAUTION
Carefully slide bottom cover down & out.
HOT surfaces can cause severe burns
Loosen the 2 screws at top of cover and
remove.
Chapter
See page
1-13
1-15
1-22
1-23
1-24
1-25
page 1-7
for access panel removal.
1