Advertisement

Quick Links

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GSN2821 and is the answer not in the manual?

Questions and answers

Summary of Contents for Kozy-World GSN2821

  • Page 2: Safety Information Warnings

    SAFETY INFORMATION WARNINGS 4. This heater shall not be installed I M P O R TA N T: R e a d t h i s WARNING: Do not use a blower in a bedroom or bathroom. owner’s manual carefully and insert, heat exchanger insert, or other 5.
  • Page 3: Local Codes

    SAFETY INFORMATION LOCAL CODES UNPACKING Continued lnstall and use heater with care. 1. Remove top inner pack. 15. Turn off heater and let it cool before F o l l o w a l l l o c a l c o d e s . I n t h e 2.
  • Page 4: Air For Combustion And Ventilation

    AIR FOR COMBUSTION AND VENTILATION Confined and Unconfined Space Unusually Tight Construction WARNING: This heater shall not be installed in a confined space or The National Fuel Gas Code, ANS The air that leaks around doors and unusually tight construction unless Z223.1 defines a confined space as a windows may provide enough fresh provisions are provided for adequate...
  • Page 5 3. Add the Btu/Hr of all fuel burning appliances in the space. Vent-free heater Btu/Hr Example: Gas water heater* Btu/Hr Gas water heater 30,000 Btu/Hr Gas furnace Btu/Hr Vent-free heater 26,000 Btu/Hr Vented gas heater Btu/Hr Total 56,000 Btu/Hr Gas heater logs Btu/Hr Other gas appliances* + Btu/Hr...
  • Page 6: Installation

    FOR GSP2822 use propane/LP gas walls. FOR GSN2821 use Natural gas. Use only propane/Lp gas. If your gas supply is not propane/LP gas, do not install heater. Call dealer where you...
  • Page 7: Clearances To Combustibles

    CLEARANCES TO INSTALLATION ITEMS FOR LP models COMBUSTIBLES NEEDED The installer must supply an external (Vent-Free Operation Only) Before installing heater, make sure regulator. The external regulator will Carefully follow the instructions below. you have the items listed below. reduce incoming gas pressure. You This stove is a freestanding unit piping (check local codes) must reduce incoming gas pressure...
  • Page 10 ACCESSORY PF06-YJLF-F Route ends of 4-wire power cord 14. Check to make sure that the and thermostat switch up from power cord is completely clear Tools required: Phillips screwdriver the lower control compartment of blower wheel and there are NOTICE: Shut off gas heater during through the rubber bushing, then no foreign objects in blower the following blower installation.
  • Page 13: Specifications

    Installing Logs, page on the front of this manual. When 9, to properly replace logs. contacting your dealer or Kozy-World, Replace log(s) if broken or chipped have ready: (dime-sized or larger). Your name...
  • Page 14: Troubleshooting

    TROUBLESHOOTING Note : All troubleshooting WARNING: Only a CAUTION: Never use a wire, items are listed in order of qualified service person needle, or similar object to operation. should service and repair clean ODS/pilot. This can heater. damage ODS/pilot unit. OBSERVED PROBLEM POSSIBLE CAUSE REMEDY...
  • Page 15 TROUBLESHOOTING Continued POSSIBLE CAUSE OBSERVED PROBLEM REMEDY 1. Burner orifice is clogged. Bu r n e r(s )d oes not l ight after 1. Clean burner orifice (see Cleaning 2. Inlet gas pressure is too low. ODS/pilot is lit. Maintenance) replace 3.
  • Page 16 TROUBLESHOOTING Continued WARNING: If you smell gas Shut off gas supply. Do not try to light any appliance. Do not touch any electrical switch; do not use any phone in your building. Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
  • Page 18 PARTS LIST This list contains replaceable parts used in your heater. When ordering parts, follow the instructions listed under Replacement Parts on page 13 GSN2821 of this manual. GSP2822...
  • Page 19 ILLUSTRATED PARTS BREAKDOWN GSN2821 GSP2822...
  • Page 20 PARTS LIST This list contains replaceable parts used in your heater.When ordering parts ,follow the GSP2822 instructions listed under Replacement Parts on page 13 of this manual. GSN2821...
  • Page 21: Log Placing Instructions

    LOG PLACING INSTRUCTIONS Follow the precedures below and the successive drawings to put log sets in place to the gas pedestal stove (indoor vent-free): Take out the paper liner (See DRAWING 1). DRAWING 1 Take away the screen from the appliance, and remove the logs pack- age (See DRAWING 2).
  • Page 23 INSTALLING THE DECORATING LOGS OF GSN2821/GSP2822 1. Fasten log A and B separately on the correspon- dent angle iron(See Figure 2). 2. Insert the pinhole on the upper part of log C into the pin on the left side of log A. Place the lower part of log C on the flat roof at the left side of log B(See Figure 3).

This manual is also suitable for:

Gsp2822

Table of Contents