Replacing The Ups Equipped With A Hotswap Mbp; Recycling The Used Equipment - Eaton 9PX 700 RT Installation And User Manual

6. UPS maintenance
6.5

Replacing the UPS equipped with a HotSwap MBP

1
MBP-120
LOAD
6.6

Recycling the used equipment

Contact your local recycling or hazardous waste center for information on proper disposal of the used
equipment.
• Do not dispose of the battery or batteries in a fire. Batteries may explode. Proper disposal of batte-
ries is required. Refer to your local codes for disposal requirements.
• Do not open or mutilate the battery or batteries. Released electrolyte is harmful to the skin and eyes.
It may be toxic.
Do not discard the UPS or the UPS batteries in the trash. This product contains sealed, lead acid
batteries and must be disposed of properly. For more information, contact your local recycling/
reuse or hazardous waste center.
Do not discard waste electrical or electronic equipment (WEEE) in the trash. For proper disposal,
contact your local recycling/reuse or hazardous waste center.
Page 38
2 3 8 4
9 11 10
29
33
The HotSwap MBP module makes it
5 6
possible to service or even replace
the UPS without affecting the connected
loads.
Maintenance
1. Set switch
7
28
2. Stop the UPS by pressing the
Return to normal operation
1. Check that the UPS is correctly
34 35 36
2. Start the UPS by pressing the
15
3. Set switch
to Bypass position.
33
The red LED on the HotSwap MBP
module goes ON, indicating that the
load is supplied directly with AC input
source power.
button on the UPS control panel.
LED "UPS ON - OK to switch"
31
goes OFF , the UPS can now be
disconnected and replaced.
connected to the HotSwap MBP
module.
button on the UPS control panel.
LED "UPS ON - OK to switch" on
31
the HotSwap MBP module goes ON
(otherwise, there is a connection error
between the HotSwap MBP module
and the UPS).
to Normal position.
33
The red LED on the HotSwap MBP
module goes OFF .
9PX 1-3 KVA US_EN