Table of Contents
Advertisement
Hearthstone Quality Home Heating Products, Inc
6. Using a 10mm wrench, remove the pilot gas line to access the orifice.
7. Remove the existing pilot orifice and replace with the #27 provided in this kit.
8. Reinstall making sure to align the notch appropriately and tighten the pilot gas line then reinstall the pilot
assembly making sure the gasket is intact.
9. Remove the #8 screw holding the NG air collar to the burner tube and remove the collar. Reinstall the #8
screw in the burner tube (a replacement screw is included in this kit).
10. Using a 9/16" deep socket, replace the burner orifice in the firebox with the #58 orifice included in this kit.
11. Reinstall the burner in the fireplace and tighten four (4) screws removed in step #3 above.
12. Reinstall the valve assembly and tighten the three (3) screws removed in step #2 above.
13. Using a flat tip screw driver, remove the fuel conversion screw from the valve, switch the plug to LP and
reinstall as shown below.
EUROPA Series 8900
19
Advertisement
Table of Contents
