Getting Started; Installing The Filter; Positioning The Dehumidifier - Philips DE5205 User Manual

3 Getting started

Installing the filter

Note
Make sure that the appliance is
•
unplugged before installing the
filter.
Before using the appliance, remove all
packaging materials from the filter and
place the filter into the appliance as
described as follows.
1
Pull the top part of the rear panel to
remove it from the appliance
(fig.c).
2
Take out the HEPA filter and the
pre-filter (fig.d).
3
Remove all packaging materials
from the HEPA filter (fig.e).
4
Place the HEPA filter into the
dehumidifier and then the pre-filter
(fig.f).
Note
Make sure that the HEPA filter and
•
the pre-filter are properly attached
to the dehumidifier.
5
Reattach the rear cover by pressing
the bottom part of the rear cover
onto the appliance first (1). Then,
gently push the rear cover against
the body of the appliance (2)
(fig.g).
6
Wash your hands thoroughly after
installing filters.
Positioning the
dehumidifier
To increase the dehumidifying
effectiveness, position the dehumidifier
in a location that can draw the most air.
Note
When the dehumidifier is operating,
•
do not open exterior doors or
windows.
EN 7