Estun pronet series User Manual page 107

Para. No.
[0] Clear error pulse when S-0FF, not clear error pulse
when overtravel.
Pn004.1
[1] Not clear error pulse
[2] Clear error pulse When S-OFF or over travel
￭Looking for the reference point
Looking for the reference point is for establishing a zero physical point of the operating platform, which is used as zero
point in the coordinates during point position control. And users may choose to find a reference point either in forward or
reverse side.
How to find a reference point
Mount a limit switch in the forward or reverse side.Find a reference point in the forward direction after connecting to /PCL
and in the reverse direction after connecting to /NCL. When the operating platform bumps into the limit the switch, the
motor will first stop according to the way set by Pn004.0, and then rotate again against limit the switch. When the
operating platform leaves the limit switch and the motor reaches the position of first photo encoder Phase C pulse,then
position of operating platform is set to be the zero point of the coordinates.
How to find related parameters of reference point
Speed towards limit switch is called "speed of looking for reference point ", and the moving speed away from limit switch is
called " moving speed". These two speeds could be set by the following parameters:
Para. No.
Speed of looking for reference point (hits
Pn685
the limit switch)
Moving speed (move away from limit
Pn686
switch)
Usually, the set speed of the reference point (Pn685) is high, and the moving speed (Pn686) is low. Note: if moving
speed is too high, precision of finding a reference point would be affected.
When looking for a reference point, /PCL and /NCL are no longer programmed to limit external current.
Name and description
Description
ProNet Series AC Servo User' s Manual
Unit Setting range
rpm 0~3000
rpm 0~200
- 105 -
Setting
Default
range
0~2 0
Default
1500
30