Isdn Pri Circuit; Isdn Bri Lines - Samsung OfficeServ500 Installation Manual

6-2 Chapter 6
Connecting Central Office Circuits

ISDN PRI Circuit

Using a standard, straight-through 8-conductor data cable or straight-through 8-conductor line
cord, connect the Network Terminating Unit to the TEPRI card as shown in

ISDN BRI Lines

The Basic Rate Interface (BRI) card can be used as ISDN TE (Terminal Equipment) or NT2
(Network Termination 2 / Multi-way ISDN Interface). When programmed to T-mode, the default
setting, this port provides T point
NOTE: When you are connecting a T port to an NT, please take care if there is a
termination present in any place on the bus other than this BRI card—typical 100 Ohm line
termination resistance exists on each port of this card
For ISDN station interface as S point of NT2, see
(Figure 6-6a).
Chapter
Figure
(Figure 6-6b).
7.
6-5.