Two Cabinet Installation - Floor Mount - Samsung OfficeServ500 Installation Manual

2-2 Chapter 2
Installing Single and Multiple Cabinet Configurations
Single Cabinet Installation
A single cabinet system can be wall-mounted using two screws in the rear keyholes, or floor mounted
with the standard legs provided or optional locking castors. (The castor kit must be ordered.) Remove
the side and front covers of the cabinet prior to installation to avoid damaging the covers and to allow
access to the interior.
To rack mount the cabinet, see
For a Wall-Mounted System
The cabinet should be securely mounted on a plywood backboard at least 1.5 cm (5/8 inch) thick. In-
sert two screws (minimum size #10 or 2.6mm) into the backboard, 40 cm (16 inches) apart.
2–1.) Hang the cabinet onto the screws installed in the backboard.
Proceed with the installation of the power supply unit(s), grounding, power connections, control cards
interface cards and optional equipment as described in the following chapters.
For a Floor-Mounted System
Locate the optional legs or locking castors. Remove the side and front covers of the cabinet prior to
installation to avoid damaging the covers and to allow access to the interior. Place the cabinet on a
secure surface (floor or workbench) with the front of the cabinet (card slots) facing up. With the sup-
plied screws, mount the legs or castors on each corner of the cabinet
upright in the desired location.
Proceed with the installation of the power supply unit(s), grounding, power connections, control cards,
interface cards and optional equipment as described in the following chapters.

Two Cabinet Installation - Floor Mount

One cabinet is to act as the main key service unit (KSU), the other as an expansion cabinet. Check
that each cabinet carton includes the following items:
OfficeServ500 cabinet
Top cover
Left and right side covers
Front cover
Cabinet leg mounting kit
AC power and DC power cables
Check that all additional hardware and software is available for installation.
Floor mounting equipment (legs or castors).
Cards required to make the system functional (i.e., power supply, central processor, station an
trunk cards)
- Wall or Floor Mount
Rack Mounting Cabinets in this chapter.
(Figure 2−2). Place the cabinet
(Figure