Chapter 8 Connecting Optional Equipment; Music On Hold/Background Music; External Paging - Samsung OfficeServ500 Installation Manual

Chapter 8 Connecting Optional Equipment

Optional equipment covered in this chapter includes:
Music-On-Hold/Background Music

External Paging

Ring Over Page
Printer for SMDR/UCD/traffic/alarm reports
Common Bell
PC for programming
Voice Mail/Auto Attendant (customer-provided)
(For full details of MMC programming for these options, see the Samsung Combined Systems
Programming Manual.)

Music On Hold/Background Music

Connect each customer-provided music source to the music input on a MISC daughter-
board (Figure
Each C.O. line (trunk) can be programmed to receive a music source, system-generated
tone or 'NO MUSIC' when it is put on hold. Each keyset can receive a music source or
'NO MUSIC' for background music.
External Paging
Each MISC daughterboard provides a voice pair and a dry contact pair to be used with cus-
tomer-provided paging equipment. Connect the customer-provided paging equipment to the
page output pins of a MISC daughterboard
zone in MMC 605.
The page voice pair is 600 Ohm impedance. If the amplifier page input is not 600 Ohm, use an
impedance matching transformer. The paging contact pairs are for control of low voltage circuits
or amplifier output. The contacts are rated at 24 VDC–1 amp.
WARNING: Do not attempt to connect commercial AC power to these contacts.
8-1).
(Figure 8-2). The relay must be assigned to the page
8-1