Before Installing; Steam Room Requirements - mr. steam MS-65 Installation, Operation & Maintenance Manual

BEFORE INSTALLING
IMPORTANT
Take a minute to read these instructions before installing or servicing. Although this MS
steambath generator has been fully qualified for shipment by MR. STEAM, the following must
be reviewed for proper, safe and enjoyable steam bathing.
- Verify that the model and accessories are correct, including incoming line voltage.
- Insure steambath generator has been correctly selected for the steambath room. Pay
particular attention to room volume and construction. If any questions, please refer to
MR. STEAM sizing guide enclosed. (see page 9)
- Marble or glass walls or ceilings, or exterior walls "ENLARGE" the room's size,
requiring a generator larger than one based only on the room's cubic foot (L x H x W)
volume.
- The physical size of the unit, clearance for plumbing servicing and its distance from the
steam room must all be considered before final installation.
•
IMPORTANT
MR. STEAM units intended to be operated with optional accessories, such as digital timer
and/or temperature controls, are to be installed strictly in accordance with the specific
instructions supplied with these optional accessories and the information contained in this
manual.
STEAM ROOM REQUIREMENTS
1. Steam room must be completely enclosed, with full walls, door, floor and ceiling.
2. It is recommended that a gasketed door is used for heat sealing and steam containment.
3. If tile-type flooring is used, install anti-skid strips or equivalent, for safety.
4. Walls and ceilings must be covered with water-resistant, non-corrosive surface, such as
tile, molded acrylic, fiberglass, etc.
5. Provide a floor drain.
•
•
—2—