Summary of Contents for mr. steam Steam@home SAH3000
Page 1
Installation, Operation & Maintenance Manual Steam@Home ® RESIDENTIAL STEAM GENERATOR SYSTEMS Models: SAH3000, SAH4500, SAH6000 steam ® Feel Good Inc.
Page 2
READ ME FIRST! WA R N I N G states a hazard may cause serious injury or death if precautions are not followed. IMPORTANT NOTE: As you follow these instructions, you will notice warning and caution symbols. This blocked infor- C A U T I O N signals a situation where minor injury or mation is important for the safe and efficient installation,...
• Add B1 suffix to Model No. for 208V/1Ph • All Mr.Steam SAH Models are cULus Listed and CE approved. All SAH Generators available in 240v/1PH and 208v/1PH. SAH units are not available in 3 phase. Specify voltage with order.
Mr.Steam SAH units are intended to be oper- IMPORTANT NOTE: tion and maintenance information. Leave this ated with a Mr.Steam SteamStart™ control only, and are to be document with the homeowner. Do not discard installed strictly in accordance with the specific instructions con- this document.
SteamStart Installation section (pg. 12) for specific thinners, or the like. Installation in areas having high con- details. centrations of chlorine (such as pool equipment room) Mr.Steam Generators (inclusive of the SteamStart™ NOTE: must be avoided. series controls) are CE and UL listed.
Use could cause confusion or interfere with the Mr.Steam control’s intended use and function. Acrylic Shield PN MS-103938. See instructions provided with steam shield.
Page 8
steam Steam Home ® ® Installation, Operation & Maintenance Manual ________________________________________________________________________ INSTALLATION PLUMBING All plumbing shall be performed by a qualified licensed plumber and in accordance with applicable National and local codes. • Use unions on all pipe connections. • Use only brass piping or copper tubing as permitted by codes. •...
Page 9
steam Steam Home ® ® Installation, Operation & Maintenance Manual ________________________________________________________________________ Oil Well INSTALLATION OF THE STEAM HEAD ⁄ ” NPT, PN 103937) Acrylic Shield 103938) WITH ACRYLIC SHIELD (PN 103938) The Acrylic Shield (PN 103938) is for use when acrylic or other Acrylic Shield 103938) non-heat resistant materials are used for the steamroom enclosure.
Page 10
steam Steam Home ® ® Installation, Operation & Maintenance Manual ________________________________________________________________________ ELECTRICAL CHART _____________________________________________________________________________ All electrical wiring to be installed by a qualified Max Room Wire Size licensed electrician in accordance with National Model Volume Volts† Phase AMPS (AWG) for up to (Cu.
2 seconds and try again. TROUBLESHOOTING WA R N I N G ELECTRICAL SHOCK HAZ- ARD. Mr.Steam steam generators are connected to 240V line voltage and contain live electrical components. All installation and service to be performed by qualified and licensed electricians and plumbers only.
Page 12
steam Steam Home ® ® Installation, Operation & Maintenance Manual ________________________________________________________________________ SINGLE PHASE 208/240 VOLT WIRING DIAGRAMS SAH units are not available in 3 phase MODELS: SAH3000 L E G E N D (All Diagrams) SAH4500 FIELD WIRING SAH6000 FACTORY WIRING SteamStart™...
Page 13
steam Steam Home ® ® Installation, Operation & Maintenance Manual ________________________________________________________________________ MODELS SAH3000, SAH4500, SAH6000 shown with cover removed Contactor Transformer Liquid Level Control Board Water Feed Solenoid Power Supply Opening SteamStart ™ Steam Outlet Safety Valve Drain Valve (shown in closed position) Heating Element Stainless Steel Tank NOTE: FOR ILLUSTRATIVE PURPOSES ONLY.
DIAGRAM 1 valves, body sprays or similar accessories within the shower could cause confusion or interfere with the Mr.Steam con- trol’s intended use and function. Diagram 2 STEP 1 - Drill a 7/8 inch diameter hole in a preferred wall location.
Use essential oils with caution. • Place the drops into the Mr.Steam AromaSteam steamhead recess prior to turning on the steambath. Do not place drops in Steam emission slot a hot steam head as SERIOUS INJURY CAN RESULT IF YOU DO NOT FOLLOW THIS WARNING.
Need help?
Do you have a question about the Steam@home SAH3000 and is the answer not in the manual?
Questions and answers