Positioning - Delta HCH1850 User Manual

Levelers
After moving the unit into place, use a
wrench to rotate clockwise the four levelers
be-side the casters to put them down and
stable on the floor. Make sure the unit
cannot slide or topple.
3.4

Positioning

After moving the unit into place and it is parallel with the adjacent cabinet, you must position
it so as to ensure its stability. The following two methods can be used, depending on the
installation environment:
Cabinet fasteners
If the adjacent cabinets are Delta cabinets (MSR1110 and MSR2110), you may use
necting fasteners (two at the front and two at the rear). You must remove the front and
back doors before making the fastener connection. Refer to the following procedures:
1
If the front door is locked, use the attached key to open it.
2
and ground wire
door
WARNING:
The levelers are only used for
leveling the unit and cannot be
used to compensate for the height
difference of the floor so as to
avoid toppling.
, raise the front
1
, and take it out.
2
(Figure 3-3: Leveling feet)
13
Chapter 3 Installation
(Figure 3-4 : Open the front door)