Positioning - Delta RowCool HCH1CH0 User Manual

3.4

Positioning

After moving the unit into place and it is parallel with the adjacent cabinet, you must position
it so as to ensure its stability. The following two methods can be used, depending on the
Cabinet fasteners
If DELTA cabinet (Model number MSR1110, MSR2110) is used as the adjacent cabinet, it
can be fastened by connecting fasteners. Each cooling unit is provided with four connecting
fasteners (two at the front and two at the rear). You must remove the front and back doors
1
2
3
4
5
6
InfraSuite RowCool Precision Cooling –
Chilled Water
If the front door is locked, please use the attached key to open it.
Remove the unit's earth wire and the control panel interface cable, raise the front
door, and take it out.
Use the key to unlock the rear door, remove the earth wire, raise the door, and take it
out. The rear door is of the split type and, if necessary, take down both doors.
NOTE: Put the front and rear doors that have been removed in a safe place so
as to avoid any equipment damage or personal injury due to collisions.
Use a screwdriver to loosen the screw below the fastener and lock it on the adjacent
cabinet.
(Precision Cooling Unit)
(Figure 3-4: Join the cooling unit and the adjacent cabinet together)
(Adjacent cabinet)
14