Timing Belt Inspection; Lubrication Points - Mercury 40 JET FOURSTROKE Operation, Maintenance & Installation Manual

Timing Belt Inspection

Inspect the timing belt and have it replaced by an authorized dealer if any of the
following conditions are found.
• Cracks in the back of the belt or in the base of the belt teeth.
• Excessive wear at the roots of the cogs.
• Rubber portion swollen by oil.
• Belt surfaces roughened.
• Signs of wear on edges or outer surfaces of belt.

Lubrication Points

1. Lubricate the following with Quicksilver or Mercury Precision 2‑4‑C with
PTFE.
Tube Ref
Description
No.
2-4-C with PTFE
95
IMPORTANT: It is important not to use a general all‑purpose grease for this
bearing. The lubricant recommended is a water‑resistant grease of the proper
consistency for this application. If a substitute is used, be sure that it is
water‑resistant.
• Driveshaft bearing
i. Pull vent hose off of the grease fitting.
ii. Pump in grease through the grease fitting, using the grease gun
provided, until excess grease starts to exit the vent hose.
MAINTENANCE
26958
Where Used
Driveshaft bearing
58
Part No.
92-802859A 1
eng