Mercury 40 JET FOURSTROKE Operation, Maintenance & Installation Manual page 50

2. Connect the remote fuel line to the outboard. Make sure the connector is
snapped into place.
3. Position the fuel line primer bulb so the arrow on the side of the bulb is
pointing up. Squeeze the fuel line primer bulb several times until it feels
firm.
4. Set the lanyard stop switch to "RUN" position. Refer to General
Information ‑ Lanyard Stop Switch.
5. Shift outboard to neutral ("N") position.
6. Set the throttle grip to start position.
OPERATION
28526
27348
19791
N
28522
40
eng