11. THERMISTORS removal
Cut the cable tie.
12. SOLENOID COILS (4way valve and Solenoid valves) removal
Remove the mounting screw.
13. EEV COILS removal
Remove the EEV coil by hand.
There are two coils.
14. PRESSURE SENSORS removal
Low pressure
sensor
High pressure
sensor
Remove the heat insulation.
Remove the SOLENOID COIL.
Remove the PRESSURE SENSOR
with wrench.
There are two sensors.
(High and Low pressure)
Note the tightening torque at the installation.
Tightening torque is 15 1.5N m.
06-10
Thermo spring
Remove the thermo spring and
thermistor.