ZyXEL Communications ZyWALL 110 Handbook & Instructions page 127

12
Ensure that the L2TP Address Pool does not conflict with any existing LAN1, LAN2,
DMZ, or WLAN zones, even if they are not in use.
13
If you cannot access devices in the local network, verify that the devices in the local
network set the USG's IP as their default gateway to utilize the L2TP tunnel.
14
Make sure the ZyWALL/USG units' security policies allow IPSec VPN traffic. IKE uses
UDP port 500, AH uses IP protocol 51, and ESP uses IP protocol 50.
15
Verify that the Zone is set correctly in the VPN Connection rule. This should be set
to IPSec_VPN Zone so that security policies are applied properly.
www.zyxel.com
127/255