Table D-3 Display Command Summary - Keithley 2001 Operator's Manual

SCPI Command Subsystems
Table D-2 (cont.)
CALibrate command summary
Command
:CALibration
:PROTected
:LLEVel
:STEP <Step #>
10
11
12
13
14
15
:STEP?
:CALCulate
:DC
:ZERO
:LOW <NRf>
:HIGH <NRf>
:LOHM <NRf>
:HOHM <NRf>
:OPEN
:CALCulate
:UNPRotected
:ACCompensation
Table D-3
DISPlay command summary
Command
:DISPlay
[:WINDow[1]]
:TEXT
:DATA <a>
:DATA?
:STATe <b>
:STATe?
:DATA?
:WINDow2
:TEXT
:DATA <a>
:DATA?
:STATe <b>
:STATe?
:DATA?
:CNDisplay
:SMESsage <b>
:SMESsage?
:ENABle <b>
:ENABle?
D-4
Description
-2V DC step.
0V DC step.
20mA AC at 1kHz step.
+0.2A DC step.
+2A DC step.
2V AC at 1Hz step.
Request the current calibration step.
Calculate low-level cal constants.
User calibration subsystem.
Low-thermal short calibration step.
+2V DC calibration step.
+20V DC calibration step.
20k Ω calibration step.
1M Ω calibration step.
Open circuit calibration step.
Calculate DC cal constants.
All commands in this subsystem are not protected by CAL switch.
Perform user AC calibration (disconnect all cables).
Description
Path to locate message to top display.
Path to control user text messages.
Define ASCII message "a" using up to 20 characters.
Query text message.
Enable (1 or ON) or disable (0 or OFF) message mode.
Query text message mode (0 or 1).
Query data on top portion of display.
Path to locate message to bottom display.
Path to control user text messages.
Define ASCII message "a" using up to 32 characters.
Query text message.
Enable (1 or ON) or disable (0 or OFF) message mode.
Query text message mode (0 or 1).
Query data on bottom portion of display.
Clear NEXT (or PREV) display messages and cancels associated operations.
Enable (1 or ON) or disable (0 or OFF) status message mode.
Query status message mode (0 or 1).
Turn on (1 or ON) or turn off (0 or OFF) the front panel display.
Query state of the display (0 or 1).