Table 2-7 Abbreviated Scpi Command Summary - Keithley 2001 Operator's Manual

Table 2-7
Abbreviated SCPI command summary
Command
:SYSTem
:PRESet
[:SENSe[1]]
:VOLTage[:DC]
:APERture <n>
:AVERage
:COUNt <n>
:STATe ON|OFF
:NPLCycles <n>
:RANGe
[:UPPer] <n>
:AUTO <b>
:REFerence <n>
:RESolution <n>
:INITiate
:ABORt
:ARM
:LAYer2
:COUNt <n>|INF
:DELay <num>
:SOURce HOLD|IMMediate| TIMer|
MANual|BUS|TLINk| EXTernal
:TIMer <num>
:TRIGger
:COUNt <n>|INF
:DELay <num>
:SOURce HOLD|IMMediate|MANual|
BUS| TLINK| EXTernal|TIMer
:TIMer <num>
:ROUTe
:CLOSe <list>
:STATe?
:OPEN <list>|ALL
:SCAN <list>
:EXTernal <list>
Notes:
1. Command short form is indicated by the uppercase characters. For example, instead of sending ":arm:layer2:source immediate", you can send
":arm:lay2:sour imm".
2. The brackets [ ] indicate optional names that need not be sent. For example: [:SENSe[1]]:VOLTage:DC:RANGe:[UPPer] 5 is the same as
:VOLTage:DC:RANGe 5.
Description
Subsystem command path.
Set unit to a default configuration (see Appendix B).
Subsystem command path.
Path to configure DC voltage.
Specify integration time in seconds (n = 166.67e-6 to 200e-3).
Path to control averaging filter:
Specify number of points to average (n = 1 to 100).
Enable/disable averaging filter.
Specify integration time in number of line cycles (n = 0.01 to 10).
Path to configure measurement range:
Select range (n = -1100 to +1100).
Enable (1 or ON) or disable (0 or OFF) autorange.
Specify REL value (n = -1100 to +1100).
Specify measurement resolution (number of digits; n = 4 to 8).
Initiate one trigger (measure) cycle.
Reset trigger system and go to idle state.
Subsystem command path to configure scan:
Path to program scan layer:
Program number of scans (1 to 99999 or INFinite).
Program delay (0 to 999999.999sec).
Select event to control scan trigger.
Set timer interval (0.001 to 999999.999sec).
Subsystem command path to program measure layer:
Program number of measurements (1 to 99999, or INFinite).
Program delay (0 to 999999.999sec).
Select event to control measure trigger.
Set timer interval (0.001 to 999999.999sec).
Subsystem command path for scanning.
Path and command to close channel.
Request closed status of channel list.
Open specified channels.
Path and command to specify internal list.
Command to specify external list.
Getting Started
2-15