Heat Sink/Fan Assembly - HP EliteBook 820 G4 Maintenance And Service Manual

Heat sink/fan assembly

NOTE: The heat sink/fan assembly spare part kit includes replacement thermal material.
Description
Heat sink/thermal module with fans
Before removing the heat sink/fan assembly, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the heat sink/fan assembly:
▲ Disconnect the fan cable (1), loosen the six captive screws on the fan and heat sink following the
sequence stamped on the fan and heat sink (2), and then remove the heat sink/fan assembly from the
system board (3).
CAUTION:
fragile and can be easily damaged and bent during removal.
NOTE:
system board components each time the heat sink is removed. Replacement thermal material is
included with the heat sink, processor, and system board spare part kits.
56 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Bottom cover on page
Battery on page
Take extreme care when removing the heat sink and fan assembly. The heatpipe is very
The thermal material must be thoroughly cleaned from the surfaces of the heat sink and the
30).
35).
Spare part number
821691-001