Solid-State Drive - HP EliteBook 820 G4 Maintenance And Service Manual

Solid-state drive

Description
512 GB, PCIe Gen3×4 NVMe SS/DS MLC
512 GB, PCIe NVMe TLC
512 GB, PCIe, Gen3x4, self-encrypting (SED), Opal 2, TLC
512 GB, SATA-3, FIPS-140-2, TLC
360 GB, PCIe Gen3×4 SS TLC
256 GB, PCIe NVMe TLC
256 GB, SATA-3 SS TLC (Opal 2)
128 GB, SATA-3, SS value
NOTE: Only one mass storage device (hard drive or a solid-state drive) can be installed.
Before removing the solid-state drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery (see
Remove the solid-state drive:
1. Remove the Phillips M2.0×3.0 screw (1) that secures the drive to the system board.
38 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
Bottom cover on page
Battery on page 35).
30).
Spare part number
915952-001
915954-001
915953-001
915955-001
915951-001
915950-001
915949-001
915948-001