Table of Contents
Advertisement
ESAB FABRICATOR 141i
8.04 Installing Control PCB2 and Clear Protective Sheet
1. Install 4 screws.
2 Plug harness into DRIVE connector.
3. Plug harness into SOURCE connector.
4. Plug harness into CR connector.
5. Plug harness into FUNs connector
6. Plug harness into NTCs connector.
7. Plug harness into IGBT OT connector .
8. Plug harness into GUN connector.
9. Plug harness into QF/DY connector.
10. Plug harness into WVIN connector.
11 Plug harness into MB connector.
12. Plug harness into PWM connector.
13. Plug harness into IFB connector.
Verify harness connections with the system schematic to ensure all connections are correct.
14. Install clear protective sheet.
ASSEMBLY PROCEDURES
6
Art # A-12183
8-4
Manual 0-5448
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
