TrainMaster Command operations
Reprogramming R2LC circuit boards to restore features
D
ue to the inevitable derailments, static,
and the nature of electricity, it is possi-
ble that your R2LC could someday lose its
setup program. The symptoms of this condi-
Step 1: Move switch on locomotive from
run to program.
Step 2: Turn on Command Base.
Step 3: Place locomotive on track, then
turn on power to track.
Step 4: Press "ENG" then input locomo-
tive's ID#. Press "SET".
Step 5: Press "ENG", then the ID#, "AUX1",
then press 43 for your locomotive.
tion would be unresponsiveness in command
mode. This can be easily remedied by "repro-
gramming" your R2LC using the following
steps.
Step 6: Turn off power to track, wait ten
seconds.
Step 7: Remove locomotive from track,
move switch from program to run.
Step 8: Place locomotive back on track,
turn power on to track.
Step 9: Press "ENG" and ID#, then operate
as normal.
23