Experiencing The Range Of Your Locomotive's Railsounds System - Lionel 4-6-4 Hudson Owner's Manual

Upgrades to your locomotive

Experiencing the range of your locomotive's RailSounds system

W ith RailSounds, you experience the
sounds of real railroading like never
before. Simply put, it's the most sophisti-
cated, authentic model railroad sound sys-
tem in the world.
• Variable chuff rate. Your
Locomotive's speed determines the steam
chuff rate.
• MultiWhistle™. Different whistles
every time—a RailSounds exclusive.
• Authentic bell. Press BELL on your
CAB-1 or transformer to begin the effect,
again to discontinue. Even the final "hit"
is muted like the real thing.
• Reverse unit reset sound. Power
down your track, wait for 3-5 seconds, and
Command Control Upgrade
T his upgrade is made using kit 6-22960,
which includes a radio circuit board.
Begin by removing the die-cast locomotive
cab as described on page 10. First, unplug the
104E unit circuit board and set it aside. Pull
straight up from its mounting pins to remove
it. Next plug in the circuit board (R2LC) into
the slot marked "Radio" (same slot as the
104E unit used).
Finally, locate the jumper
marked JP1. Move the
jumper from the
listen for the air-release sound—that's
the Locomotive telling you its 104 E
reverse unit has just reset to forward
operation.
• Shutdown sequence. No other model
railroad sound system shuts down like
RailSounds. Turn off track power, and
after the air-release reset sound, you have
two seconds to restart your Locomotive. If
you're done with operations, RailSounds
will commence with an authentic steam
locomotive shutdown sequence about two
seconds after the air-release reset occurs.
NOTE: Battery must be installed for shut-
down sequence.
conventional location to the command loca-
tion. (See page 16 for exact location.)
Note: The antenna in your upgrade kit is not
needed. One has been provided with your
locomotive and is already wired in.
15