Information On The Display Panel - Bosch WAWH8660GB Instruction Manual And Installation Instructions

Information on the display panel

Indicator
- P - and ÿ
- P -
ÿ is flashing
ù is flashing
r is lit continuously
E:18
E:23
E
Å is lit
continuously
The indicator light for
the Drum Clean
programme* is
flashing
* Depending on the
model
|
Other indicators
Cause/remedy
The door is unlocked. It is possible to add laundry.
The temperature is too high. Wait until the temperature drops.
■
The water level is too high. It is not possible to add laundry. Close the door
■
immediately, if necessary. Press the A button to resume the programme.
Laundry may be trapped. Open and close the door again and press the A
■
button.
If necessary, push the door closed or remove the trapped laundry and then
■
push it closed again.
If necessary, switch the appliance off and then on again; set a programme and
■
apply the settings you require; start the programme.
The detergent drawer has not been pushed in fully. Push the drawer in correctly.
Turn the tap on fully,
■
The supply hose is kinked/trapped,
■
The water pressure is too low. Clean the filter. ~ Page 59
■
The drain pump is blocked. Clean the drain pump. ~ Page 58
■
The drain hose/drain pipe is blocked. Clean the drain hose at the siphon.
■
~ Page 59
There is water in the base trough; the appliance is leaking. Turn off the tap. Call the
after-sales service. ~ Page 64
The childproof lock is activated – deactivate it. ~ Page 43
Too much foam has been detected and additional wash cycles have been activated.
Add less detergent to the next wash cycle with the same load.
Run the Drum Clean 90 °C programme or a 60 °C programme to clean and care
for the drum and the outer tub.
Notes
Run the programme without laundry.
■
Use standard washing powder or a detergent that contains bleach. To prevent
■
foaming, only use half the amount of detergent recommended by the detergent
manufacturer. Do not use detergents intended for woollens or delicates.
Switching the information signal on/off ~ Page 54
■
Off: Wi-Fi is switched off and the appliance is not connected to your home network.
Flashing: The appliance is trying to connect to your home network.
Continuously lit: Wi-Fi is switched on and the appliance is connected to your home
network.
Switch off the appliance, wait for 5 seconds and then switch it back on. If the
indicator appears again, call the after-sales service. ~ Page 64
Faults and what to do about them.
en
61