Table of Contents
Advertisement
o
Home Connect
T his appliance is Wi-Fi enabled and can
H o m e C o n n e c t
be controlled remotely via a smartphone
or tablet PC.
With the Home Connect app, you can
use your smartphone or tablet PC to do
the following on this appliance:
Select and start programmes.
■
Change programme settings.
■
Query the status of programmes.
■
Change appliance settings.
■
Switch off the appliance.
■
Before you can use the Home Connect
functions, you will need to install the
Home Connect app on your
smartphone or tablet PC, register,
connect your appliance automatically or
manually to your home Wi-Fi network
(you only need to do this the first time)
and then connect your mobile device to
your appliance via the
Home Connect app.
You can find information about the app
on our Home Connect website
www.home-connect.com.
Notes
Please observe the safety
■
precautions in this instruction
manual and make sure that these
are complied with even when
operating the appliance via the
Home Connect app while you are
away from home. You must also
follow the instructions in the
Home Connect app.
You cannot use the
■
Home Connect app to make
changes while the appliance is in
operation. You will be able to use the
Home Connect app to see any
adjustments made directly on the
appliance itself, however.
Connecting to your home
network automatically
If your router has a WPS function, you
can connect the appliance to your home
network automatically.
If your router does not have a WPS
function, you will need to connect the
appliance to your home network
manually .
Wi-Fi must be switched on on the
appliance.
Switch the appliance on.
1.
Press and hold the Remote Start }
2.
button for more than 3 seconds.
'ž£ (connect automatically) will
appear on the display panel.
Press the Start button to connect. †
3.
will flash on the display panel.
The appliance will now try to connect
to your home network.
Activate the WPS function on your
4.
home network router within the next
2 minutes.
If the appliance has connected to your
home network successfully, ™©Ÿ
(connected) will appear on the display
panel and † will be lit continuously.
You can exit the Home Connect
5.
settings by pressing the Remote
Start } button.
If a connection could not be
Note:
established, "§§ (fault) will appear on
the display panel. Check whether your
appliance is in range of your home
network.Try connecting automatically
again or connect your appliance
manually ~ Page 50.
Home Connect
en
49
Hide quick links:
Advertisement
Table of Contents
