Everyday Use; Basic Settings - Bosch WAWH8660GB Instruction Manual And Installation Instructions

Table of Contents

Advertisement

Intelligent dosing system
en
When the appliance is switched on, the
fact that the detergent drawer is closed
completely is indicated by the following:
If intelligent dosagei-DOS w or
i-DOS i has been selected, the
corresponding indicator lights up.
If intelligent dosage has not been
selected, the indicator flashes once
and then goes out.
The ù symbol in the display panel
goes out.

Everyday use

Indicator lights in the display panel:
The display lights up if intelligent
dosage has been selected for the
dispenser.
The display flashes if the fill level of
the selected intelligent dosing
dispenser is below the minimum
level.
(De)selecting intelligent dosage and
adjusting the dosage strength:
The intelligent dosages for detergent
and fabric softener are set at the factory
for programmes in which intelligent
dosage can be used.
Overview of programmes ~ Page 32
The dosage strength has been preset to
low (lightly soiled laundry) for
detergent w and to medium (medium
level of softness) for fabric softener i. It
can be changed for each programme.
~ Page 39
46
In addition to intelligent dosage,
cleaning aids (e.g. stain remover) can
be added manually to compartment
v u, if necessary. ~ Page 47
The selection (on/off) and the
Note:
selected dosage strength for i-DOS i
and i-DOS w are saved for each
programme until they are changed
again, even if the washing machine is
switched off.
Topping up the detergent/ fabric
softener:
If the indicator light for the selected
intelligent dosage flashes, this means
that the amount of detergent or fabric
softener in the dispenser is below the
minimum fill level. The contents will last
for another three washes or so.
The same detergent or fabric softener
can be added at any time. If you change
product/manufacturer, we recommend
that you clean the dispensers first.
~ Page 57
If required, adjust the basic dosage.

Basic settings

The basic dosages are:
For detergents – based on the
manufacturer's recommendation for
average soiling and the respective
water hardness.
F or fabric softeners – based on the
manufacturer's recommendation for
a medium level of softness.
Refer to the packaging label on your
detergent/fabric softener or ask the
manufacturer directly for this
information.
To find out the hardness of your water
supply, use a test strip or check with
your water supplier.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents