Before Washing For The First Time - Bosch WAWH8660GB Instruction Manual And Installation Instructions

Positioning and connecting
en
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory. To
remove any water that may be left over
from the test, run the first wash cycle
without any laundry.
Notes
The washing machine must be
■
correctly installed and connected.
(from ~ Page 14)
Never use a damaged machine.
■
Inform the after-sales service.
Preparatory work:
Check the machine.
1.
Fill the dispenser ß and i.
2.
~ Page 45
Remove the protective film from the
3.
control panel.
Plug into the mains.
4.
Turn on the tap.
5.
Run the programme without laundry:
Switch on the appliance.
1.
Close the door (do not load any
2.
laundry).
Set the Drum Clean 90 °C
3.
programme.
Open the detergent drawer.
4.
Pour approx. 1 litre of water into
5.
compartment v u.
Pour standard washing powder into
6.
compartment v uII.
To prevent foaming, only use
Note:
half of the amount of detergent
recommended by the detergent
manufacturer. Do not use detergents
that are intended for wool or
delicates.
Close the detergent drawer.
7.
Press the A button.
8.
Switch off the appliance at the end of
9.
the programme.
Your washing machine is now ready to
use.
22