Start The Programme; Child Lock 3 Sec; Adding Laundry; Changing The Programme - Bosch WAWH8660GB Instruction Manual And Installation Instructions

Start the programme

Press the A button. The indicator lamp
lights up and the programme starts.
The display panel shows the "Ready in"
time while the programme is running or
the programme length and the
programme progress symbols when the
washing programme has started.
Display panel ~ Page 28
Note: Foam detection
If the Å symbol also lights up in the
display panel, the washing machine has
detected too much foam during the
wash programme and automatically
activated additional rinse cycles to
remove the foam.
Add less detergent to the next washing
cycle with the same load.
If you want to lock the programme to
prevent it from being inadvertently
adjusted, you can select the childproof
lock as follows.

Child Lock 3 sec.

(E)
You can lock the washing machine to
prevent the functions you have set from
being changed inadvertently. To do this,
activate the childproof lock.
To activate/deactivate, press and hold
the Finished In - and + buttons at the
same time for approx. three seconds.
The E symbol is appears in the display
panel.
E lights up: The childproof lock is
■
active.
E flashes briefly: The childproof lock
■
is active and the programme
selector was turned or a button was
pressed.
Operating the appliance
The childproof lock remains
Note:
active, even once the washing machine
has been switched off. Before selecting
the next programme, deactivate the
childproof lock.

Adding laundry

After starting the programme, you can
add or remove laundry if necessary.
Press the A button to do this.
The A button indicator lamp flashes
and the machine checks whether it is
possible to add laundry.
If the following appears in the display
panel:
Both the - P - and ÿ symbols light
■
up, it is possible to add laundry.
- P - lights up, it is not possible to
■
add laundry.
To continue the programme, press the
A button. The programme continues
automatically.
Notes
Do not leave the door open for too
■
long when adding laundry as water
from the laundry may leak out.
For safety reasons, the door remains
■
locked when the water level or
temperature is high, or while the
drum is turning, and it is not possible
to add laundry during this time.
The load display is not active during
■
reloading.

Changing the programme

If you have started the wrong
programme by mistake, you can
change the programme as follows:
Press the A button.
1.
Select another programme.
2.
Press the A button. The new
3.
programme starts from the
beginning.
en
43