Switching Between Tis Operating Modes - Garmin G500 Pilot's Manual

Traffic Map Page
Annunciation
NO DATA*
DATA FAILED*
FAILED*
UNAVAILABLE
* Contact a service center or Garmin dealer for corrective action
The traffic mode is annunciated in the upper left corner of the Traffic Map
Page. When the aircraft is on the ground, TIS automatically enters Standby
Mode. If traffic is selected for display on another map while Standby Mode is
selected, the traffic display enabled icon is crossed out (also the case when TIS
has failed). Once the aircraft is airborne, TIS switches to Operating Mode and
traffic information is displayed. The mode can be changed manually using soft
keys or the page menu.
Traffic Mode Annunciation
Mode
TIS Operating
TIS Standby
(Also shown in white in center of
TIS Failed*

Switching Between TIS Operating Modes

1) Turn the large MFD knob to the MAP page group and then turn the small MFD
knob to the Traffic Map Page.
2) Select the STANDBY or OPERATE soft key to switch between modes. The mode
is displayed in the upper left corner of the Traffic Map Page.
OR
190-01102-02 Rev. E
Data is not being received from the transponder
Data is being received from the transponder, but
a failure is detected in the data stream
The transponder has failed
TIS is unavailable or out of range
Table 4-11 TIS Failure Annunciations
(Traffic Map Page)
OPERATING
STANDBY
page)
FAIL
Table 4-12 TIS Modes
Garmin G500 Pilot's Guide
Description
Traffic Display Enabled Icon
(Other Maps)
4-29