Remove the power steering cover and fill cap to check the fluid level. The fluid
level should be slightly below the bottom of the fill hole. Use Synthetic Power
Steering Fluid SAE 0W‑30, if needed.
a -
Power steering cover
b -
Fill cap
c -
Fill/full level
Tube Ref
Description
No.
Synthetic Power
Steering Fluid SAE
138
0W-30
Changing Engine Oil
ENGINE OIL CAPACITY
Engine oil capacity is approximately 6.0 liter (6.3 US qt).
PUMP METHOD
IMPORTANT: Tilt outboard out/up past vertical for approximately one minute to
allow trapped oil to drain back to the oil sump.
IMPORTANT: To reduce or prevent oil spillage when removing the oil filter,
ensure the outboard is upright (not tilted) and the engine is cold or has not run
for at least one hour.
1. Tilt outboard out/up past vertical for approximately one minute to allow
trapped oil to drain back to the oil sump.
2. Place the outboard in a vertical position.
3. Remove dipstick and slide adapter tube of crankcase oil pump through oil
dipstick hole, to bottom of engine oil sump.
MAINTENANCE
a
Where Used
Power steering system
88
b
c
29315
Part No.
92-858077K01
eng