Dts Wiring System; Accessory Drive Belt Inspection; Lubrication Points - Mercury 135 Verado FourStroke Operation And Maintenance Manual

Assemble the steering link rod to the engine with special washer head bolt and
self‑locking nylon insert locknut. First torque the bolt, then torque the locknut to
specifications.

DTS Wiring System

Splicing or probing will damage the wire insulation allowing water to enter the
wiring. Water intrusion may lead to wiring failure and loss of throttle and shift
control. To avoid the possibility of serious injury or death from loss of boat
control, do not splice or probe into any wire insulation of the DTS system.
• Verify the harnesses are not routed near sharp edges, hot surfaces, or
moving parts.
• Verify all unused connectors and receptacles are covered with a weather
cap.
• Verify the harnesses are fastened along the routing path.

Accessory Drive Belt Inspection

Inspect the accessory drive belt and have it replaced by an authorized dealer if
any of the following conditions are found.
• Cracks in the back of the belt or in the base of V grooves.
• Excessive wear at the roots of the grooves.
• Rubber portion swollen by oil.
• Belt surfaces roughened.
• Signs of wear on edges or outer surfaces of belt.

Lubrication Points

1. Lubricate the following with Extreme Grease.
Tube Ref
Description
No.
Extreme Grease
eng
MAINTENANCE
WARNING
!
Where Used
Trim rod ball ends
83
Part No.
8M0071842