Speaker - HP Compaq Pro 4300 Maintenance And Service Manual

8. Route the cables through the slots beneath the drive cage, pull the assembly (right side first) into
the chassis, and then remove the assembly from the computer.
Figure 7-45
To install the front I/O and power switch assembly, reverse the removal procedure.
NOTE: Be sure to correctly route the cables beneath the drive cage when reinstalling the assembly.
Proper cable routing prevents damage to the cables and allows the drive cage to close properly.

Speaker

Description
Speaker
The speaker is attached to the front of the chassis under the rotating drive cage.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. Rotate the drive cage to its upright position.
5. Disconnect the speaker wire from the white system board labeled SPKR
6. Remove the two screws that secure the speaker to the chassis (1).
Routing the cables and removing the power switch assembly
(Computer Access Panel on page
(Front Bezel on page
(Preparation for Disassembly on page
50).
51).
Spare part number
636925-001
48).
Speaker 83