Axminster ATDP13B User Manual page 12

Assembly
Fig30-31
Micro switch unit
Cutout slot
Micro switch cable
6. Undo the clamping knob to the side of the micro switch
sufficiently to allow the guard rail to slide up through the
centre of switch.
7. Locate the chuck guard and rail assembly (7). Turn the guard
over and slot the rail into the guard's mounting channel, insert
the two square clamps into the rail's 'T' slot and secure by
nipping up the Phillips screws. DO NOT OVERTIGHTEN to
avoid the plastic guard from cracking, see fig 29-30-31.
Fig 29-30-31
Square clamp
Rail
18
7
Clamping screws
8. Introduce the chuck guard rail (7) up through the centre of
the micro switch and nip up the clamping knob to lock the
chuck guard in place, see fig 32.
NOTE: You can re-adjust the guard's height for different
drilling operations.
Morse taper arbor and chuck
9. Locate the keyless chuck (11) and Morse taper arbor (12).
Insert the Morse taper arbor into the keyless chuck then slot
the assembly up into the quill until it's firmly home. Place a
piece of timber on the table, turn the lever feed handle (9)
down until the chuck is up against the timber and press
firmly down. The Morse taper (12) should now be locked
tight inside the quill, stopping the assembly from
12 dropping out, see fig 33-34-35.
Fig 32
7