Table A-25 General Card Specifications; Table A-26 System Interface; Mgx-Frsm-8E1 Specification - Cisco MGX 8850 Installation And Configuration Manual

MGX-FRSM-8E1 Specification

MGX-FRSM-8E1 Specification
This section provides information on the operation of the MGX-FRSM-8E1 card set. Topics are:
•
System-level interface. (See Table A-29.)
•
General physical information about the card set. (See Table A-30.)
•
Information about the Frame Relay service. (See Table A-31.)
•
Statistics and counters. (See Table A-32.)
Table A-29
Category
ATM Layer:
AAL Layer:
FR-Cell Interworking:
Table A-30
Category
Line Interface connector:
Line Rate:
Synchronization:
Input Jitter Tolerance:
Output Jitter Generation:
Physical Layer Alarms:
Indicators per card:
Indicators per line:
Maintenance/Serviceability
Features:
Reliability, MTBF:
Card Size:
Power:
A-22 Cisco MGX 8850 Installation and Configuration, Release 1.1.10, Part Number 78-6186-03
System Interface
Description
Per ITU-T I.361 and ATM UNI v3.1
AAL5 per Draft CCITT I.363
Per Draft CCITT I.555 and I.36x.1, as summarized in Frame Relay Forum,
FR/ATM PVC Interworking Implementation Agreement FERF.5
General Card Specifications
Description
RJ-48 when used with RJ-48-8E1 line module
SMB when used with SMB-8E1 line module
2.048 Mbps ± 100 bps
Transmitter may be either loop-timed to Receiver or synchronized to
normal
shelf (
Per G.703
Per G.703
LOS, OOF, AIS, RAI
Active (Green), Standby (Yellow), Fail (Red)
Active & Okay (Green)
Active & Local Alarm (Red)
Active & Remote Alarm (Yellow)
Internal Problem Isolation Loopbacks
Hot-pluggable cards
> 65000 hours
MGX-FRSM-8E1: 7.25" x 16.25" (18.43 cm x 41.28 cm)
RJ48-8E1: 7.0" x 4.5" (17.78 cm x 11.43 cm)
SMB-8E1: 7.0" x 4.5" (17.78 cm x 11.43 cm)
–48V DC, 30W with 8 active E1 lines
mode)