Table of Contents
Advertisement
Setup using a Web Browser
Your Browser must support JavaScript. The configuration program has been
tested on the following browsers:
•
Netscape V4.08 or later
•
Internet Explorer V4 or later
Setup Procedure
Before commencing, install the Wireless Access Point in your LAN, as described
previously.
1. Check the Wireless Access Point to determine its Default Name. This is shown on
a label on the base or rear, and is in the following format:
SCxxxxxx
Where xxxxxx is a set of 6 Hex characters ( 0 ~ 9, and A ~ F).
2. Use a PC which is already connected to your LAN, either by a wired connection or
another Access Point.
•
Until the Wireless Access Point is configured, establishing a Wireless connec-
tion to it may be not possible.
•
If your LAN contains a Router or Routers, ensure the PC used for configura-
tion is on the same LAN segment as the Wireless Access Point.
3. Start your Web browser.
4. In the Address box, enter "HTTP://" and the Default Name of the Wireless Access
Point
e.g.
HTTP://SC2D631A
5. You should then see a login prompt, which will ask for a User Name and Pass-
word.
Enter admin for the User Name, and password for the Password.
These are the default values. The password can and should be changed. Always
enter the current user name and password, as set on the Change Password
screen.
12
Figure 7: Password Dialog
SIGNAMAX LLC •
www.signamax.eu
Advertisement
Table of Contents
