Table of Contents
Advertisement
Wireless Access Points
The main panel displays a list of all Wireless Access Points found on the network. For
each Access Point, the following data is shown:
Name
IP address
MAC Address
IEEE Stan-
dard
FW Version
Description
Note: If the desired Wireless Access Point is not listed, check that the device is
installed and ON, then update the list by clicking the Refresh button.
Buttons
Reset to Default
Refresh
Detail
Web Management
Set IP Address
Exit
10
Figure 6: Management utility Screen
The Name is shown on a sticker on the base of the device.
The IP address for the Wireless Access Point.
The hardware or physical address of the Wireless Access Point.
The wireless standard or standards used by the Wireless Access
Point (e.g. 802.11b, 802.11g)
The current Firmware version installed in the Wireless Access
Point.
Any extra information for the Wireless Access Point, entered by
the administrator.
Click this button to reset the Wireless Access Point with
default settings.
Click this button to update the Wireless Access Point device
listing after changing the name or IP Address.
When clicked, additional information about the selected
Access Point will be displayed.
Use this button to connect to the Wireless Access Point's
Web-based management interface.
Click this button if you want to change the IP Address of the
Wireless Access Point.
Exit the Management utility program by clicking this button.
SIGNAMAX LLC •
www.signamax.eu
Advertisement
Table of Contents
