Display Problems - Getac v100 User Manual

Make sure that the distance between the two devices are not over 10

meters or that there are no walls or other obstructions between the
devices.
 Make sure that the other device is not in "Hidden" mode.
 Make sure that both devices are compatible.

Display Problems

Nothing appears on the screen.
During operation, the screen may automatically turn off as a result of

power management. Press any key to see if the screen comes back.
The brightness level might be too low. Increase brightness by pressing

the Fn+F6 hot key.
The display output might be set to an external device. To switch the

display back to the LCD, press the Fn+F9 hot key or change the display
through the settings in Display Properties.
The characters on the screen are dim.
Adjust the brightness and/or contrast.

Bad dots appear on the display at all times.
A small number of missing, discolored, or bright dots on the screen are

an intrinsic characteristic of TFT LCD technology. It is not regarded as a
LCD defect.
Resolution cannot be adjusted to desired setting.
 Make sure that the VGA driver is installed correctly.
The external monitor displays nothing.
 Make sure that the monitor is turned on.
 Make sure that the monitor's signal cable is properly connected.
 Switch the display to the monitor by pressing the Fn+F9 hot key or
change the display through the settings in Display Properties.