Network Dome Camera · Quick Start Guide Thank you for purchasing our product. If there are any questions, or requests, please do not hesitate to contact the dealer. About This Document This manual applies to the following models. Model This manual may contain several technical incorrect places or printing errors, and the content is subject to change without notice.
Network Dome Camera · Quick Start Guide FCC Information FCC compliance: This equipment has been tested and found to comply with the limits for a digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
Page 4
Network Dome Camera · Quick Start Guide municipal waste in the European Union. For proper recycling, return this product to your local supplier upon the purchase of equivalent new equipment, or dispose of it at designated collection points. For more information see: www.recyclethis.info. 2006/66/EC (battery directive): This product contains a battery that cannot be disposed of as unsorted municipal waste in the European Union.
Network Dome Camera · Quick Start Guide Safety Instruction These instructions are intended to ensure that user can use the product correctly to avoid danger or property loss. The precaution measure is divided into “Warnings” and “Cautions” Warnings: Serious injury or death may occur if any of the warnings are neglected.
Page 6
Network Dome Camera · Quick Start Guide ● Do not connect several devices to one power adapter as adapter overload may cause over-heating or a fire hazard. ● Please make sure that the plug is firmly connected to the power socket.
Page 7
Network Dome Camera · Quick Start Guide damp locations, and do not expose it to high electromagnetic radiation. ● To avoid heat accumulation, good ventilation is required for operating environment. ● Keep the camera away from liquid while in use. ●...
Network Dome Camera · Quick Start Guide 1 Appearance Description Overview The overview of the network bullet camera is shown below. Figure 1-1 Overview Table 1-1 Description Description Photoresistor Lens Sun Shield 3-axis Bracket Network Cable Interface...
Network Dome Camera · Quick Start Guide Description Power Cable Interface Alarm Cable Interface Video Cable Interface Audio Out Audio In Reset Button Micro SD Card Slot Serial Port The standard power supply is 12V DC or 24V AC, please make sure ...
Page 11
Network Dome Camera · Quick Start Guide Slot Cover Figure 1-2 Remove Card Cover 2. Insert the SD card into the SD card slot. Micro SD Card Figure 1-3 Insert the Card 3. (Optional) Push the inserted micro SD card inside to remove the micro SD card.
Network Dome Camera · Quick Start Guide 2 Installation Before you start: ● Make sure the device in the package is in good condition and all the assembly parts are included. ● The standard power supply is 12V DC or 24V AC, please make sure your power supply matches with your camera.
Network Dome Camera · Quick Start Guide 2.1 Ceiling Mounting Steps: 1. Drill the screw holes and the cable hole in the ceiling according to the supplied drill template. Ceiling Mounting 1:Screw Hole for 2:Screw Hole for Bracket Mounting Base Figure 2-1 Drill Template 2.
Page 14
Network Dome Camera · Quick Start Guide Please insert the expansion screws first if the camera is mounted to the cement ceiling. And you can use the self-tapping screws directly if camera is mounted to the wooden ceiling. Figure 2-2 Install the Camera 3.
Page 15
Network Dome Camera · Quick Start Guide 0° ~ 360° 0° ~ 360° 0° ~ 100° Figure 2-3 Adjust the Surveillance Angle Figure 2-4 Supplied Wrench 4. (Optional) Install the water-proof jacket for network interface. It is recommended to adopt the water-proof jacket (supplied) for the network interface when the camera is installed outdoor.
Page 16
Network Dome Camera · Quick Start Guide 2). Route the network cable through the following components in sequence: fix nut, water-proof ring, and the main body of the water-proof jacket, as shown in the figure. 3). Insert the water-proof ring into the main body of the water-proof jacket, to increase the sealing ability of the components.
Network Dome Camera · Quick Start Guide 2.2 Wall Mounting with a Junction Box Steps: 1. Drill the screw hole and cable hole according to the supplied drill template (shown as Figure 2-1). 2. Align the screw holes of the junction box to the drill template, and fix the junction box to the wall with screws.
Network Dome Camera · Quick Start Guide 2.3 Wall Mounting with a Gang Box An adapter plate should be purchased separately if you mount the camera to a gang box. Steps: 1. Install the adapter plate to the gang box. 2.
To view and configure the camera via LAN (Local Area Network), you need to connect the network camera in the same subnet with your PC. Then, install the Advidia Camera Finder Utility to search and change the IP of network camera.
Page 20
This search may take 30 seconds or more depending on network size. After searching it will show total number and information of the Advidia cameras found on the network. Device information including the device type, IP address, port number, gateway, etc.
Network Dome Camera · Quick Start Guide Click the refresh icon to refresh the online device list manually. The newly discovered devices will be added to the list. Note: You can click on each column heading to order the information. ...
Page 22
Network Dome Camera · Quick Start Guide Login Manager Figure 3-4 Launch Edit Table Figure 3-5...
Page 23
Network Dome Camera · Quick Start Guide Edit Table Figure 3-6 5) Enter the desired IP address (or range if changing the IP address of more than one device) of the network camera in the address field of the edit table and click Apply Network Changes. You can also select “Dynamic IP”...
Network Dome Camera · Quick Start Guide 4 Accessing via Web Browser System Requirement: Operating System: Microsoft Windows XP SP1 and above version / Vista / Win7 / Server 2003 / Server 2008 32bits CPU: Intel Pentium IV 3.0 GHz or higher RAM: 1G or higher Display: 1024×768 resolution or higher Web Browser: Internet Explorer 6.0 and above version, Apple Safari...
Page 25
Network Dome Camera · Quick Start Guide Login Interface Figure 4-1 5) Install the plug-in before viewing the live video and managing the camera. Please follow the installation prompts to install the plug-in. Note: You may have to close the web browser to finish the installation of the plug-in.
Page 26
Network Dome Camera · Quick Start Guide Download Plug-in Figure 4-2 Install Plug-in Figure 4-3...
Page 27
Network Dome Camera · Quick Start Guide Install Plug-in Figure 4-4 6) Reopen the web browser after the installation of the plug-in and repeat the above steps 2-4 to login. Note: For detailed instructions of further configuration, please refer to the camera’s user man...