Configuring the Ports
Port settings
–
For devices with PoE select the
Basic Settings:Power over Ethernet dialog.
–
For devices with PoE+ select the
Basic Settings:Power over Ethernet Plus:Port dialog.
The table only shows ports that support PoE.
In the "POE on" column, you can enable/disable PoE at this port.
The "Status" column indicates the PoE status of the port.
In the "Priority" column (MACH 4000), set the PoE priority of the port
to "low", "high" or "critical".
The "Class" column indicates the class of the connected device:
Class: Maximum delivered power
0: 15.4 W = As-delivered state
1: 4.0 W
2: 7.0 W
3: 15.4 W
4: reserved, treated as Class 0
The column „Consumption [W]" displays the current power
delivered at the respective port.
The "Name" column indicates the name of the port, see
Basic settings:Port configuration.
Figure 20: Power over Ethernet dialog
84
UM Basic Configuration L3P
Release 7.1 12/2011