System Configuration Via Bootp - Hirschmann PowerMICE User Manual

Entering the IP Parameters
2.5 System configuration via
BOOTP
When it is started up via BOOTP (bootstrap protocol), a device receives its
configuration data in accordance with the "BOOTP process" flow chart
fig. 13).
Note: In its delivery state, the device gets its configuration data from the
DHCP server.
 Activate BOOTP to receive the configuration data
based IP Configuration"), or see the CLI:
enable
network protocol bootp
copy system:running-config
nvram:startup-config
y
 Provide the BOOTP server with the following data for a device:
# /etc/bootptab for BOOTP-daemon bootpd
#
# gw -- gateway
# ha -- hardware address
# ht -- hardware type
# ip -- IP address
# sm -- subnet mask
# tc -- template
.global:\
:gw=0.0.0.0:\
:sm=255.255.240.0:
UM Basic Configuration L3P
Release 7.1 12/2011

2.5 System configuration via BOOTP

(see on page 50 "Web-
Switch to the privileged EXEC mode.
Activate BOOTP.
Activate BOOTP.
Confirm save.
(see
41