Burn In - Kanguru KCLONE-5HD-SATA User Manual

Burn In

8.23 Burn In
The BURN IN function allows the system to perform a Copy, Compare, Verify, Erase or Load function
continuously to stress test for endurance, reliability and stability.
To perform a continuous burn in test:
1. From the ADVANCED SETUP menu, tap the 'SET' button to navigate to the BURN IN option.
2. The BURN IN option is disabled by default. Tap the 'RUN' button to enable it.
3. Tap the 'RUN' button to configure the BURN IN COUNT option. The BURN IN COUNT can
be set to: 5, 10, 15, 20, 50 or MX. The number here will tell the system how many times it should
repeat the Burn In test. If set to MX, the Burn In test will run continuously until you manually
stop it.
4. Tap the 'SET' button to confirm your selection.
5. From the ADVANCED SETUP menu, hold the 'SET' button to return to the SETUP menu.
6. From the SETUP menu, hold the 'SET' button to return to the Main menu.
7. Tap the 'SET' button to navigate to the mode that you want to test.
8. Tap the 'RUN' button to begin the burn in test.
9. Once the operation has completed the screen will display the total execution time and the
operation count. Once this information has been displayed for a few seconds the operation will
start again automatically. This will be repeated until the BURN IN COUNT value configured in
step 3 has been reached.
10. You can stop the burn in test at any time by tapping either the 'SET' button or 'RUN' button
during operation. This will automatically disable the Burn In function and the duplicator will
return to normal functionality.
38