Need Resize; Format Source - Kanguru KCLONE-5HD-SATA User Manual

Need Resize / Format Source

8.19 Need Resize

Note: The NEED RESIZE option configures the way that the Smart copy operates (see section 3.1
Smart on page 13).
When you execute a Smart copy operation, the system will check the capacity between the Source
and all connected Target drives. If the capacity of any of the Target drives exceeds the capacity of the
Source drive by the tolerance percentage defined by the NEED RESIZE option, then the duplicator
will automatically execute a Resize copy. Tap the 'RUN' button to change this option.
For example:
• [ 0%] : All targets must be the same capacity. If the capacity between the Source and Targets is
different than the system will execute a Resize copy.
• [10%] : If the capacity between the Source and Targets is between 0% and 10% then the system
will execute a Brief copy. If the capacity of the Targets is larger than the capacity of the Master
by more than 10% then the system will execute a Resize copy.
The default value is: 3%

8.20 Format Source

The FORMAT SOURCE operation allows you to format a hard drive as a Storage Center. Storage
Centers can be used to store hard drive images for convenient access to your most commonly used
Source files. For more information on using a Storage Center see section 5.2 Duplicating From a
Storage Center on page 18.
To format a hard drive as a Storage Center:
1. Connect the hard drive you want to format as a Storage Center to the duplicator's Source port.
2. In the Advanced Setup menu, navigate to FORMAT SOURCE and then tap the 'RUN' button
to format the hard drive.
3. You will receive a message asking you to confirm formatting the drive. Tap the 'RUN' button
to proceed or tap the 'SET' button to cancel.
Caution! Formatting the internal hard drive will erase any saved image files stored on the hard
drive.
Once the format has completed you will receive a message confirming that the format was successful.
36