Connecting Charger To Power Supply - Stihl HSA 66 Instruction Manual

English
Working Technique
Verrical cut
Swing the cutting blade from the bottom
upwards in an arc – lower the nose of the
blade, move along the hedge and then
swing the blade up again in an arc.
Any working position above head height
is tiring. To minimize the risk of
accidents, work in such positions for
short periods only.
34
Horizontal cut
Hold the cutting blade at an angle of 0°
to 10° as you swing the hedge trimmer
horizontally, using both sides of the
blade.
Swing the cutting blade in an arc
towards the outside of the hedge so that
the cuttings are swept to the ground.
Repeat the procedure several times on
wide hedges.
Connecting Charger to
Power Supply
Power supply (mains) voltage and
operating voltage must be the same.
Insert the plug (1) in the wall
N
outlet (2).
1
A self test is performed after the charger
is connected to the power supply. During
this process, the light emitting diode (1)
on the charger lights up green for about
1 second, then red and goes off again.
HSA 66, HSA 86
2
1