the hyphen is displayed, allowing the succeeding data to be
set at the same port (at this time, the designated same port
is given some time difference),
R (Read Hex File)
R[<BIAS>]<CR>
Data of Intel Hexa Format is transferred from RS-232C inside
I/O controller to memory.
load address + <BIAS> is done before data load.
S (Substitute Memory)
S[W]<ADDR>,<OLD>[<NEW>]<CR/,>
Contents of the address <ADDR> are displayed.
contents, enter <CR/,> and change the contents, enter <NEW>
before <CR/,> entry.
* Execute read-after-write check,
X (Examine/Modify Register)
X<CR> X<REG><OLD>[<NEW>]<CR/,>
When X CR
is only designated, name and contents of each register
are displayed.
If
register is displayed.
<CR/,>.
To modify register contents, enter <NEW> and then,
<CR/,>.
When comma is entered, the contents of register with
succeeding priority are displayed according to the Table of REG
(sequence of register contents display is AX^FL).
When <BIAS> is designated, each
REG
is entered, contents of a designated
To modify the register contents, enter
7-20
To examine the